Alumax P-DR1W-48-60 Manual de usuario

OWNER’S MANUALP-DR1W-48 | P-DR1W-60SHOWER ENCLOSURESP001IT IS MANDATORY TO HAVE A WALL STUD ON EACH SIDE OF THE SHOWER UNIT TO SECURELY FASTEN

1012Mark the screw locations on the walls on both sides of shower. Remove the running rail (1) sllaw ni seloh llirD .)2( stekcarb llaw eht

118SLIDING DOORInstall sliding door (6) ensuring that rollers (5) are xed over the running rail (1).Ensure that sliding door (6) is placed wit

12HANDLE9Install bottom rollers, making sure that they are tangent to the running rail (1).See sheet for installation and install the handle as shown.

1310GASKETS INSTALLATION Thoroughly clean the edge of the sliding door, closest to the side where the handle is located. Apply the door gasket (9) to

14SILICONE1210Adjust the position of the stoppers (3) so as to ensure a maximum opening and closing range. Ensure that the sliding door gasket (9) is

2PANNEAU FIXE/FIXED PANEL1PARTS LISTING ... 3PROVIDED HARDWARE ...

31PARTS LISTING 252133467810121114131591617 ITEM PARTS QTY1RUNNING RAIL 12WALL BRACKET 23STOPPERS 24GLASS HOLDE

4TOOLSHARDWAREPENCILDRILL SILICONESCREWDRIVERSCUTTING PLIER LEVELTAPE MEASURE181920 If the shower panels are to be assembled on ceramic tiles, use a 1

5GASKET INSTALLATION 11B1APlace door panel (6) inside tub to simplify following installation procedures. Ensure placing the panel onto a cushion

6RUNNING RAIL 22A2B1 Position the stoppers (3) on the running rail (1) as illustrated. Secure them temporarily in place.- Position the wall brackets

74GLASS CLIPS3GLASS HOLDERS11 Ensure that the running rail (1) is at the highest pos-sible position in reference to the holes of the xed panel (7).

85FIXED PANEL PLACEMEMENT5BPosition the xed panel assembly (7) on thresh-old of base (B) as shown .Adjust the xed panel (7), by way of the running r

96 stekcarb llaw eht rof snoitacol wercs eht kraM(2) on the walls on both sides of shower as well as the placement of the bottom glass clips(11) (13)